Satloc FALCON - Page 42

Section Two
39
www.Satloc.com Falcon User Manual, Rev A
Test Flow Control for Liquid
Tap the
‘Diagnostics’
Scroll down to
‘Flow Diagnostics.’
en, tap ‘Flow
Diagnostics’
e ow status
information will
appear on the
screen.
Tap ‘Start Test
Valve Movement’
to run valve test.
Tap ‘Move’ button
to set movement
amount
Tap ‘Open Valve
per Time’ to
open valve by set
amount
Tap ‘Close Valve
per Time’ to
close valve by set
amount
Tap ‘Full Open’ to
fully open valve
Tap ‘Full Close’ to
fully close valve
Tap ‘Go To
Encoder Value’ to
set encoder value
Enter desired
encoder value.
en, tap ‘Ok.’