To complete the installation you will need the appropriate interface cable to
connect the printer to the output port of the host computer. These can be pur-
chased locally or from your SATO supplier. If you need additional informa-
tion on interface types, connector types or cabling pin-outs, please refer to
Section 5 of the Operator Manual.
The most common interface connections are Parallel and RS232 Serial.
Parallel Interface
The Parallel interface connector is an AMP 57-40360 female 36 pin Cen-
tronics type.
Pin # Description
1 Strobe
2-9 Data bits 0-7
10 Acknowledge
11 Busy
12 Out of Paper
13 +5VDC
17 Chassis Ground
31 Reset
32 +5VDC
16, 33
19-30
Signal Ground
There are no DSW configuration switch settings required for the parallel in-
terface.
18
19
36
1
Plug-In Interface
Card
Interface
Connector
CL408/412 Quick Guide
PN 9001067 Rev A Page 8
To Next Page
Loading...
