To Next Page
J
jessicabraunAug 7, 2025
What to do if SATO CL612e Printer beeps with FRAMING ERROR message?
- SscottbishopAug 7, 2025
If your SATO Printer is beeping and displaying a FRAMING ERROR message when data is sent, it means there's a mismatch in the RS232 data format settings. Here’s what you should do: 1. Check that the DSW1 configuration settings for the RS232 data format match those of your host system. 2. Verify that the baud rate selected by DSW1-5 and DSW1-6 matches the host's baud rate. If they don't, adjust either the printer or the host settings to ensure they match.
General
