4
‒ Put the label through the fan-fold
opening.
Slide and adjust the label stopper
to touch the side of label slightly.
‒
‒
5
Thread the label under the label
guide and pitch sensor.
Make sure that the side of label
touches the guide roller slightly.‒
‒
‒
‒
‒
‒
‒
‒
‒
‒
‒
‒
‒
‒
‒
‒
‒
‒
*Thermal head and the
surrounding areas will become
hot during the printing process.
When changing the label after
printing, be careful not to get
burnt.
*Contacting the edge of thermal
head with bare hands may
result in injury.
When changing the labels, be
careful not to get injured.
Caution
Fan-fold label
Label stopper
Pitch sensor
Guide roller Label guide
To Next Page
Loading...
