Need help?Do you have a question about the SATO WS408TT and is the answer not in the manual?
General| Print Method | Thermal Transfer / Direct Thermal |
|---|---|
| Resolution | 203 dpi |
| Print Speed | Up to 6 ips |
| Max Print Width | 104 mm |
| Media Type | Roll and Fanfold |
| Media Width | 1 in - 4.5 in (25 mm - 114 mm) |
| Media Thickness | 0.06 mm to 0.19 mm |
| Connectivity | USB, Serial, Ethernet |
| Memory | 16 MB Flash, 32 MB SDRAM |
| Label Width | 1 in - 4.5 in (25 mm - 114 mm) |
| Label Thickness | 0.06 mm to 0.19 mm |
| Power Supply | AC 100-240V, 50/60 Hz |
| Operating Temperature | 5°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Humidity | 20 to 85% RH (non-condensing) |
Manual's scope, purpose, and target audience.
External and internal views of the printer's components.
Functions of the FEED button and LED status indicators.
Step-by-step guide for installing the cutter accessory.
Step-by-step guide for installing the dispenser accessory.
Guide to installing the Wireless LAN module.
Guide to installing the Bluetooth module.
Guide for setting up the external media unwinder.
Instructions for installing the paper support roller.
Procedure to calibrate the printer's media sensors.
Steps to restore the printer to its default state.
How to perform a self-test and enter dump mode.
Step-by-step guide to install the SATO WS4 Printer Utility.
Explains the menu bar, toolbar, and navigation pane.
Configuration of serial (COM) port settings for communication.
Configuration of network (LAN) settings for connectivity.
Step-by-step guide to establish a network connection.
Configuration options for IPv6 network addressing.
Configuration for wireless network (WLAN) connectivity.
Configuration options for Bluetooth connectivity.
Instructions for resetting utility parameter settings.
Procedures for downloading files and sending commands.
Steps to update firmware using the utility software.
Updating firmware using the network (LAN) connection.
Process for updating firmware using a USB flash drive.
Advanced firmware update method for specific cases.
Solutions for problems with the cutter and dispenser.
Troubleshooting steps for various internal printer errors.
Explanation of the printer's network communication layers.
Interpretation of Ethernet LED status lights.
Technical details about the printer's model and capabilities.
Details on media size, type, and ribbon compatibility.
List of supported one and two-dimensional barcode symbologies.
Technical details for the Wireless LAN interface.
Technical details for the Bluetooth interface.
Technical details for the Ethernet interface.
Specifications and pinouts for printer I/O ports.
Schematic of the printer's main circuit board.
Block diagram illustrating printer system components.
Diagram showing electrical connections between components.
Configuration options for the printer's DIP switches.
To Next Page
