SATO WS408TT - Self-Test and Dump Mode

WS4-TT-r01-30-12-16TM
29
3
System
Mode
Self
-
Test
and
Dump
mode
3.3
Self-Test and Dump Mode
The printer can run a self-test to print a configuration label, which helps you
understand the current settings of the printer.
3.3.1 Self-Test
1. Turn off the printer.
2. Press and hold the FEED button and turn on the printer.
3. Both status lights glow solid orange for a few seconds. Next, they turn to green
shortly and then turn to other colors. When LED 1 turns to orange and LED 2
turns to green, release the FEED button.
4. Press the FEED button to print a configuration label.
Your printer has one emulation language: SZPL. The figure below shows its
configuration label.