SATO WS408TT - Dump Mode

3
System
Mode
Self
-
Test
and
Dump
mode
WS4-TT-r01-30-12-16TM
47
3.3.2 Dump Mode
The printer enters Dump mode after running a self-test. In this mode, characters
are printed in hexadecimal codes, allowing users and engineers to debug the
system.
To return to the online mode:
■
Turn off the printer and turn it on again.
■
In Printer Utility 2013, in the Navigation pane, click Tool. In the Properties
pane, click Reboot Printer and click Send.
This is applicable for SZPL, SDPL and SEPL.