6.2
Internal Errors
Communication error (RS-232C).
■
Check the serial cable to see if it is
working okay.
■
Make sure the serial cable is connected
properly and the computer is turned on.
■
In Printer Utility 2013, the settings of the
COM port need to be the same as those
in the COM tab in Parameter.
■
The serial cable might not be wired
correctly or might be damaged. Try to
rewire it or get a new one.
Flash ROM on the CPU board
error or USB memory error.
An erase error has occurred
when formatting the USB
memory.
Unable to save files due to
insufficient USB memory.
■
Check your USB flash drive and see if it
works properly.
■
Make sure your USB flash drive is tightly
plugged.
■
The flash ROM or USB drive is damaged.
Replace it.
■
Delete the files on your USB drive to free
some space, or replace your USB drive
with an empty one.
■
Press the FEED button.
Command error.
￭
Turn off the printer, and turn it on again.
An EEPROM for backup cannot
be read or written properly.
A command has been fetched
from an odd address.
Word data has been accessed
from a place other than the
boundary of the word data.
Long word data has been
accessed from a place other
than the boundary of the long
word data.
An undefined command in a
place other than the delay slot
has been decoded.
■
It is possible that the EEPROM is
damaged. Replace it or the main board.
■
Check your commands and make sure
they are correct.
Error Solution
To Next Page
Loading...
