WS4-TT-r01-30-12-16TM
2.3
Wireless LAN Module
The Wireless LAN module provides Wireless LAN connectivity for your printer.
To install a Wireless LAN module:
Step 1. Dismantle your printer
This part describes how to remove the top cover, middle frame, tear bar and the
print module.
1. Open the top cover.
2. Loosen and remove two screws on each side of the tear bar.
3. Remove the tear bar from your printer.
4. Loosen and remove four screws from the middle frame.
5. Remove the middle frame along with the top cover
6. Loosen the four screws from the print module.
7. Move the print module aside to reveal the space below the main board.
Step 2. Secure the Wireless LAN card and connect it to the main
board
This part describes how to secure the Wireless LAN card and connect it to the
main board.
1. Plug the reflective sensor cable to the Reflective Sensor port of the Wireless
LAN card.
To Next Page
Loading...
