8 Specifications
This chapter provides specifications of the printer. Specifications are subject to
change without notice.
8.1
Printer
Print method Direct Thermal and Thermal Transfer
Resolution
203 dpi (8 dots/mm) 300 dpi (12 dots/mm)
Media Alignment Center Alignment
Standard: Continuous, Tear-off
Operation Mode
Sensor
Media Sensor
Optional: Full Cutter, Dispenser
Gap Sensor (Transmissive, Fixed) Offset: 6.27mm -
Factory Default Sensor
I-Mark Sensor (Reflective, Movable)
Head Open Switch
Ribbon Sensor
Print Speed
2, 3, 4, 5, 6 inches/sec
(50.8, 76.2, 101.6, 127, 152.4
mm/sec)
2 &3 ips for peel off mode
2, 3, 4 inches/sec
(50.8, 76.2, 101.6 mm/sec)
2 &3 ips for peel off mode
Print Darkness
Max Printable
Area
Non-Printable
Area
Print Ratio
Interface
Do not set Print Speed to 4 ips or higher speed, when the dispenser
module is installed and the dispenser cover is open.
Darkness level – SBPL: 1~5
Default – SBPL: 2
Length 999 mm x Width 104 mm Length 999 mm x Width 104 mm
Pitch Direction - Top: 1.5 mm, Bottom: 1.5 mm (excluding liner)
Width Direction - Left: 1.5 mm, Right: 1.5 mm (excluding liner)
Average print ratio within 15 % or less (whole print layout area)
Full width with 1mm pitch is required
STD Model: USB (Type A and Type B), Ethernet, RS232C
LAN Model: USB (Type A and Type B), Ethernet
WS412TT
To Next Page
Loading...
