SATO WS408TT - Bluetooth Module Installation

2
Accessories
Installation
Bluetooth
Module
WS4-TT-r01-30-12-16TM
21
2.4
Bluetooth Module
The Bluetooth module provides Bluetooth connectivity for your printer.
To install a Bluetooth module:
Step 1. Dismantle your printer
This part describes how to remove the top cover, middle frame, tear bar and the
print module.
1. Open the top cover.
2. Loosen and remove two screws on each side of the tear bar.
3. Remove the tear bar from your printer.
4. Loosen and remove four screws from the middle frame.
5. Remove the middle frame along with the top cover
6. Loosen the four screws from the print module.
7. Move the print module aside to reveal the space below the main board.
Step 2. Secure the Bluetooth card and connect it to the main board
This part describes how to secure the Bluetooth card and connect it to the main
board.
1. Plug the Bluetooth cable (white connector) to the port on the Bluetooth card.
2. Below the main board, you’ll find two screw holes on the lower-right. Align the
two holes on the Bluetooth card with them and secure the card with two
screws.