WS4-TT-r01-30-12-16TM
5. Tear off the back tape of the Wireless LAN antenna card and stick the card
besides the panel board (LED board).
6. Use the clip to fasten the antenna card.
7. Attach the antenna to the Antenna port.
Step 3. Reinstall the parts you took off
This part describes how to reinstall the parts you took off.
1. Reinstall the print module and the secure it with four screws.
2. Reinstall the middle frame along with the top cover and secure it with four
screws.
3. Reinstall the tear bar and secure it with two screws.
4. Close the top cover.
To Next Page
Loading...
