4. Do one of the following to configure your IPv4 settings:
●
If you have a static IP address, fill the IP Address, Subnet Mask and Gateway
box under IPv4 according to your network settings, make sure DHCP is disabled
and click Send.
●
If you don’t have a static IP address, make sure DHCP is enabled and click
Send.
5. After your printer restarts, click Get to get the IPv4 information of your printer.
If you are using a static IP address, you’ll get the same settings as it is in the
previous step; if you are using DHCP, the DHCP server will automatically
populate the IP Address, Subnet Mask and Gateway boxes under Current IPv4.
To Next Page
Loading...
