1 Accessories Installation Peeler
8
Step 3. Test the peeler
This part describes how to use the peeler to peel the liner.
1. Open the peeler.
2. Place the media roll between the holders. Make sure the print side is up and
the media roll is clamped tightly by the holders.
3. Pull the media until it reaches out of your printer. Thread the media under the
media guides.
4. Remove 1-3 labels from the liner at the start of the media.
5. Thread the liner under the plate (beside the platen roller) and the peeler, until
the first label touches the platen roller.
6. Close the peeler and close the top cover.
7. Send a print job or press the FEED button to test if the peeler works.
To Next Page
Loading...
