1 Accessories Installation Wireless LAN Module
11
7. Loosen a screw to lift up main board.
8. Plug the Wireless LAN cable 2 (black connector) to J15 as below. Hide extra
cable under the mainboard.
9. Tear the back tape off from Wireless LAN antenna card.
10. On the front side of your printer, insert the Wireless LAN antenna card in the
notch and stick it on the module. Lead the cable in hook.
Step 3. Reinstall the base frame
This part describes how to reinstall the parts you took off.
1. Remove interface cover and reinstall the base co ver. Put the interface cover
back.
2. Secure it with 3 screws.
To Next Page
Loading...
