1 Accessories Installation Bluetooth Module Card
13
Step 2 Secure the Bluetooth card and connect it to the main board
This part describes how to connect the Bluetooth module card to the main board.
1. On the right side of your printer, locate
two screw holes below the top cover
latch and align the two holes on the
Bluetooth module card with them.
2. Secure the card with two screws.
3. Plug the Bluetooth cable (black
connector) to J15, which is the black port
located to the lower-right of the main
board.
Step 3 Reinstall the base frame
This part describes how to reinstall the parts you took off.
1. Remove interface cover and reinstall the base cover. Put the interface cover
back.
To Next Page
Loading...
