Tools Required
4mm Allen Wrench 5mm Allen Wrench #2 Phillips Head Screwdriver
Flat Head Screwdriver
Prerequisites
Disassembly steps for maintenance associated with the service kit you received requires the following
prerequisites. For now, perform ONLY the disassembly steps in the following chapters in the order listed, then
return to this chapter for the remaining instructions.
1. Motor Cover (CTS-015)
2. Remove the Blade Guard
3. Remove the saw blade - (Refer to your CTSOwner's Manual)
NOTE:
If you have been directed to this chapter from another part of this manual, the prerequisites
section of the chapter you began with might list one or more of the same prerequisites seen
above. If you've already completed a listed disassembly, move on to the next instruction.
67
|
CTS Service Manual
Retraction Bracket (CTS-029)
To Next Page