Disassembly Steps
IMPORTANT: To ensure thorough understanding, please read the instructions all the way
through before starting this procedure.
1. Rotate the elevation adjustment at
the front of your CTS clockwise to
raise the blade adjustment to it's
highest position.
2. Insert a screwdriver as shown for use as a lever:
Place the tip of the screwdriver on the nut at left (indicated with the green arrow). Next, push the
handle of the screwdriver upward with the shaft of the screwdriver just under the black, hook-shaped
hardware (indicated by a red arrow).
CTS Service Manual
|
68
Retraction Bracket (CTS-029)
To Next Page