3. With an upward prying motion, hold
the handle of the screwdriver against
the underside of the saw table, as you
rotate the elevation adjustment at the
front of your CTS to lower the blade
adjustment. This will assist with
prying the black hook from the silver
pin it straddles.
CAUTION:Be prepared for the motor to fall
freely once the black hook has cleared the
silver pin.
4. Remove the four
Bolts - M6 x 1.0mm,
16mm, Button Head, Socket [4]
indicated
in the photo using a 4mm Allen
wrench.
69
|
CTS Service Manual
Retraction Bracket (CTS-029)
To Next Page