5. See the below image for the complete IP verification checks. The node configuration process is complete
when it either returns to the command line or the output says Entering forwarding state. The configuration
process generally takes 3-5 minutes.
Common Configuration Troubleshooting
Here are some common troubleshooting steps for node configuration issues.
● Verify the node IPs were typed correctly.
● Verify the chosen LAN and Backplane IP for the node configuration are not already in use elsewhere on the
network.
● The LAN and Backplane IPs must be on separate networks. The Backplane IP cannot be a publicly routable
IP and cannot be in the assigned LAN IP network.
You can use the following commands to re-initialize and/or bypass some network verification if needed for a test
environment.
WARNING
ScaleCare Support advises against bypassing the built-in network checks unless this is for a
test or lab environment and/or ScaleCare Support has specifically advised bypassing the
checks as part of a troubleshooting process.
Use of the bypass command outside of these instances has the potential to lead to networking
issues within the initialized HC3 nodes and system that may require ScaleCare Support
intervention and/or a system wipe and reset.
1. If the node initialization failed for any reason use this command to re-configure the node:
REINITIALIZE=yes sudo scnodeinit
2. If a LAN gateway is not accessible or not responding to ICMP requests, use this command:
BYPASS_NETWORK_CHECK=yes sudo scnodeinit
3. As used here, the options to re-configure a node and bypass LAN network checks can be combined:
BYPASS_NETWORK_CHECK=yes REINITIALIZE=yes sudo scnodeinit
©
Scale Computing 2019 Version 3.0: 02/2019 | 19
To Next Page
Loading...