Scania DC16 XPI - Lubrication System; Oil Grade

Maintenance
OPM 300 en-GB 41
© Scania CV AB 2020, Sweden
Maintenance interval
Daily First time at Interval (hours) Minimum
first start 500 500 1,000 2,000 6,000 annual-
ly
every 5
years
RSMLXL
Lubrication system
Checking the oil level XX
Changing the oil
1
1. For engines that comply with Stage V, see Table Stage V.
XXXXX X
Cleaning the centrifugal oil
cleaner
X
2
2. XPI engines where Stage 3/Tier 3 or lower emissions legislation applies.
X
3
3. XPI engines where Stage 4/Tier 4 or higher emissions legislation applies.
XX
Renewing the oil filter XXXXX X
Air cleaner
Reading the vacuum indicator X XXXXX
Renewing the filter element XX X
Renewing the safety cartridge XX X
Cooling system
Checking the coolant level X X XXXXX
Checking the coolant's anti-
freeze and corrosion protection
XXXX
Changing the coolant and
cleaning the cooling system
XX
Fuel system
Checking the fuel level XX
Renewing the fuel filters
X
4
4. Applies only to DC16 072.
XXX X
Other
Checking the drive belt XXXXX
Checking for leakage X XXXXX
Checking and adjusting the
valve clearance
XXX
Renewing the reductant filter XXX X
Cleaning the reductant tank
filler filter
XXXXX
Cleaning the reductant tank
ventilation filter
XXX
Checking/renewing the partic-
ulate filter
4,500 hours
5
5. The change interval depends heavily on the average load and application type. See the Maintenance interval, particulate filter
section on the next page.