Scania DC16 XPI - Preparations for Storage

OPM 300 en-GB 105
© Scania CV AB 2020, Sweden
Other
6.
Fit the particulate filters and remove the
tools.
Note:
Check that the particulate filter brackets are not
in the way of the cover plates when they are fit-
ted. There is a risk of leakages if the cover plates
do not seal completely against the silencer.
7. Fit the cover plates with new sealing rings.
Fit and tighten the V-clamps in their original
positions.
x1
x2
402 579
Particulate filter, screw x3 32 Nm.
402 578
V-clamp, 20 Nm.