Scanreco RC400 - PROGRAMMING PARAMETERS AND SETTINGS; General description; THE SYSTEM HAS 4 LEVELS OF AUTHORISATION; Authorisation level 1. ( Installer ).

352*5$00,1*3$5$0(7(56$1'
6(77,1*6

*HQHUDOGHVFULSWLRQ

The Scanreco RC 400 offers considerable possibilities for system constructors of hydraulically
driven mobile cranes and machines. The program in the control system is very comprehensive,
flexible and has many adaptation possibilities for specific applications. The control system
offers simple programming of a number of functions which can easily be turned on or off or
altered during operation.
To obtain the best manoeuvre characteristics in the simplest way, all programming / calibr-
ation of manoeuvre characteristics is made during operation ( so called on-line ). All prog-
ramming / calibration is made from the portable control unit. Programming is simple and
does not require tools / instruments or any special knowledge.
3URJUDPPLQJFDQRIFRXUVHEHDOVRPDGHIURPD3&WHUPLQDO
The control system is furnished with and prepared for 2-way (duplex) communications and for
signal handling of functions such as ramp, parallel, lock, "dead-man’s", hold, double and
overload / lift reduction etc.
7+(6<67(0+$6/(9(/62)$87+25,6$7,21
• Authorisation level 1. ( Installer ).
• Authorisation level 2. ( Well trained installer, well trained service personnel ).
• Authorisation level 3. ( Well trained crane and valve manufacturer, well trained system
constructor ).
• Authorisation level 4. ( Scanreco AB, Sweden ).
x $XWKRULVDWLRQOHYHO,QVWDOOHU
$7RFKDQJHWKHGLUHFWLRQRIWKHFUDQH
If the crane moves in the opposite direction to that which is desired.
x $XWKRULVDWLRQOHYHO:HOOWUDLQHGLQVWDOOHUZHOOWUDLQHGVHUYLFHSHUVRQQHO

$,QGLYLGXDOFKDQJHVWRWKHPDQRHXYUHYDOYHVWDUWVSHHGIRU$RU%SRUWV
If the manoeuvre valve's starting value ”dead-band” is to be increased or decreased for A or B port.
%,QGLYLGXDOVSHHGUHGXFWLRQIRU$RU%SRUWV
Individual maximum manoeuvre speed reduction for a particular critical function ( e.g.
swing function ). Fully variable speed reduction can be made for manoeuvre valves on the A
or B ports. This enables the crane driver to pre-set the maximum oil flow for each individual
function ( A or B port ) as required.

&,QGLYLGXDOFKDQJHVWRPLFURVSHHGFRQWUROIRU$RU%SRUWV
Due to non-symmetry in certain valves hydraulic system or in the crane / machine the micro
speed can be less well defined. If this is the case the micro-speed final speed can be changed
and adjusted (i.e. for max. lever position) for A or B port for all movements.
1RWH$IWHUWKHFRPSOHWHGDGMXVWPHQWRIWKHPLFURVSHHG
7KHUHPDLQLQJPLFURVSHHGVUHGXFWLRQVWHSVZLOOEHSURSRUWLRQDOWRWKHVHWWLQJ
hydrostat.ru