MQC Series P3
Ready to Watch Some TV? (Optional)
1. Make sure your power cable is connected and the standby red light in the front of the HDTV is lit
up.
2. Check all your connection cables off the side or the back of your HDTV and also your AV
devices. Make sure they are all connected securely.
3. Turn on your HDTV and other AV devices if necessary.
4. Press the
button on the side of the HDTV or the SOURCE button on the remote control and
select the correct source according to the Connecting pages.
If You’ve Connected Antenna to the HDTV…
If an antenna or cable (without a cable box) is connected to your TV’s tuner, you will need to go through
an INITIAL SETUP process in order to watch the HDTV.
1. Press MENU to open the menu
2. Use the ◄ or ► button to select the CHANNEL icon and press
ENTER.
3. Use the ▲ or ▼ buttons to highlight the signal type and press ◄ or ► to select your connection
either AIR or CABLE.
4. Use the ▲ or ▼ buttons to select AUTO CHANNEL SEARCH and press
ENTER to scan for
channels.
5. Once the scanning finishes, you can begin to watch
HDTV
To Next Page
Loading...
Need help?
General
