EasyManuals Logo

Schaerer Coffee Art Plus Touch User Manual

Schaerer Coffee Art  Plus Touch
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
- 23 -
User Manual | 11.2016 | v01
www.schaererusa.com Error Messages
Error Messages
Display Message Cause Remedy
Grounds container missing
The grounds container was removed
(cleaning program, emptying, etc.).
The limit switch is defective.
► Insert grounds container.
If the message persists, call for service.
Empty grounds container The grounds container is full. Empty the grounds container and reinsert it.
Cleaning program A reminder appears daily at a preset time.
The machine must be cleaned.
Refer to page 19-20 for daily cleaning procedures.
Grinder left/right no beans
Appears when the bean hopper on the left-
or right is empty or when a coffee bean has
become stuck.
Beverage output is blocked!
Rell the bean hopper with coffee beans (max.
1000g.) and conrm.
Check bean slides.
If jammed, use the stem of the cleaning brush
to “stir” the coffee beans around and unclog the
grinder. Then press conrm.
Grinder left/right blocked
An object (such as a stone) has become
jammed in the left or right grinder.
Beverage output is blocked!
Check grinder for blockage and remove
remaining beans with vacuum if necessary. Then
press conrm.
If the message persists, call for service.
Heating coffee water/hot water/
steam
The temperature is 10° C below the
programmed temperature.
Wait until the temperature has been reached.
If the message persists, call for service.
Grinder current fault
• PC board defect.
• Electronics defect.
Call for service.
Brewing unit current fault
• PC board defect.
• Electronics defect.
Call for service.
Over current brew motor
Brewing unit is drawing too much current
(over 4A).
Brewing unit is jammed.
Call for service.
Water ow error
No water connection.
Pump defect. (pump pressure < 7.5bar)
Brewer is blocked.
Water system is blocked.
Grind level is too ne.
PC board and ow meter are improperly
connected.
Electrical problem (e.g. PC board).
Open the stopcock and press the beverage eld
again.
Check the brewing unit.
Check the grinder balance.
If the message persists, call for service.
Crit. coffee temp.
Electrical problem between the sensor and
PC board.
Temperature sensor defect.
Call for service.
Crit. hot water temp.
Electrical problem between the sensor and
PC board.
Temperature sensor defect.
Call for service.
Crit. steam temp.
Electrical problem between the sensor and
PC board.
Temperature sensor defect.
Call for service.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Schaerer Coffee Art Plus Touch and is the answer not in the manual?

Schaerer Coffee Art Plus Touch Specifications

General IconGeneral
BrandSchaerer
ModelCoffee Art Plus Touch
CategoryCoffee Maker
LanguageEnglish

Related product manuals