Instruction Manual for Electrobloc EBL 262-4
4
Date: 08.07.2019 8110265 BA / EN
Y ATTENTION!
Exceeding the threshold values of the 230 V mains supply!
Damage to the electrobloc, 12 V consumers or connected devices:
F It is essential that the generator conforms to the specifications of the
mains supply.
F Only connect up the generator when it is running smoothly.
F Do not connect the electrobloc to the mains supply on board passen-
ger vehicle ferries (correct mains supply is not always guaranteed on
board these ferries).
3.2 Changing the battery
Y ATTENTION!
Use of incorrect battery types or incorrectly rated batteries.
Damage to the battery or devices connected to the electrobloc:
F Batteries should only be changed by qualified personnel.
F Follow the instructions provided by the battery manufacturer.
F Only connect the electrobloc to 12 V power supplies with rechargea-
ble 6-cell lead-gel or lead-acid batteries. Do not use any unsuitable
battery types.
Y Only batteries of the same type and capacity should normally be used,
i.e. same as those installed by the manufacturer.
Y It is possible to swap lead-acid batteries with lead-gel batteries. However,
swapping from lead-gel batteries to lead-acid batteries is only possible in
certain circumstances. Contact the vehicle manufacturer for more infor-
mation.
" Electrically disconnect the battery from the electrobloc. To do this, enable
battery isolation on the IT .../LT .... control and switch panel (also see
section 3.1).
" Replace battery.
" After changing the battery, recheck which type of battery has been inser-
ted.
Y DANGER!
Incorrect setting of the battery selector switch.
Risk of explosion due to build up of explosive gases:
F Set the battery selector switch to the correct position.
" Disconnect the electrobloc from the mains before adjusting the battery
selector switch.
Generator operation and
passenger vehicle ferries
Changing the battery
To Next Page
Loading...
