Schbot Robotics Wind X2 - Installation; Cleaning Pad Attaching; Fill up the Water Tank

Installation
Open the water tank lid, fill up the water tank with clean water before
starting it, then seal the lid.
• Do not add dirty water or thick liquids into the water tank.
• Do not add corrosive or flammable liquids into the water tank.
9
Cleaning pad attaching
• Use the original cleaning pads, attach it to Wind X2 bottom properly,
the cleaning pad should not cover wheel belts or anti-falling sensors.
• Please do not spray too much water on the cleaning pads when use
to avoid slippery.
Fill up the water tank
Charging
Plug in the adapter to Wind X2 as below, connect the adapter, AC plug
and extension cable properly as in below image:
Charging Indicator:
Solid Red: Charging
Green: Fully charged after 1-2 hrs charging.
Schbot
AC Plug
Adapter
Schbot
Wind X2
Robot Window Cleaner
Extension
Cable