Scheppach BTS800 User Manual

www.scheppach.com
28
|
GB
15. Troubleshooting
Problem Possible cause Help
Motor doesn’t start
a) ON/OFF switch damaged.
b) ON/OFF cable damaged.
c) ON/OFF relay damaged.
d) Fuse blown.
e) Motor burnt.
a-d) Replace all damaged parts
before you use your machine
again.
e) Contact your local service cen-
tre. Every attempt to carry out a
repair, can be dangerous if it is
not done by skilled personnel.
Machine gets slower
during work.
Too much pressure put on the
workpiece.
Reduce the pressure on the workpiece.
Sanding belt comes
󰀨
Belt does not run straight. Reset the track.
The wood gets burnt
during sanding.
a) Sanding disc or belt covered
with grease.
b) Excessive pressure on
workpiece.
a) Replace disc or belt.
b) Reduce pressure on workpiece.

Scheppach BTS800 Specifications

General

Product type	Disc sander
Mounting type	Bench-top
On/off switch	Yes
AC input voltage	230 - 240 V
AC input frequency	50 Hz

Weight and Dimensions

Depth	560 mm
Width	280 mm
Height	320 mm
Weight	18250 g
Package weight	Weight of the packaged product in gram.