www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
55
General Chain saw
Saw chain
Chain brake
Guide bar
Clean exterior, check for damage. In case of damage have
repaired by a qualied service center immediately
Sharpen regulary, replace in good time
Have inspected regularly at an authorized service center
Turn over to ensure even wear of bearing surfaces Replace in
good time
Before each start Saw chain
Guide bar
Chain lubrication
Chain brake
OFF switch, Safety locking
button,
Throttle lever
Fuel/ oil tank cup
Inspect for damage and sharpness
Check chain tension
Check for damage
Functional check
Functional check
Functional check
Check for tightness and leckage
Every day Air lter
Guide bar
Guide bar support
Idle speed
Clean
Check for damage, clean oil intake bore
Clean, in particular the oil guide groove
Check (chain must not run)
Every week Fan housing
Cylinder space
Spark plug
Mufer
Spark arrester screen
Chain catch sleeve
Screws and nuts
Clean to ensure proper air cooling
Clean
Check and replace if necessary
Check tightness of mounting
Clean
Check for damage, replace if necessary.
Check their condition and that they are rmly secured.
Every 3 months Fuel lter
Fuel, oil tank
Replace
Clean
Storage Chain saw
Guide bar/ chain
Fuel, oil tank
Carburretor
Clean exterior, check for damage. In case of damage, have
repaired by a qualied service center immediately
Demount, clean and oil slightly Clean the guide groove of the
guide bar
Empty and clean
Run empty
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Chain, Guide bar, Chain oil, Engine oil,
Claw Stop, Chain catch, spark plug, air lter, fuel lter,
chain oil lter
* Not necessarily included in the scope of delivery!
11. Storage
Never put a chain saw into storage for longer than 30
days without carrying out the following steps.
Follow the cleaning instructions and maintenance in-
structions before storing the device!
Storage a chain saw
Storing a chain saw for longer than 30 days requires
storage maintenance. Unless the storage instructions
are followed, fuel remaining in the carburetor will
evaporate, leaving gum-like deposits. This could lead
to difcult starting and result in costly repairs.
Remove the fuel tank cap slowly to release any pres-
sure in tank. Carefully drain the fuel tank.
Start the engine and let it run until the unit stops to
remove fuel from carburetor.
Allow the engine to cool (approx. 5 minutes).
Remove the spark plug.
Pour 1 teaspoon of clean 2-cycle oil into the combus-
tion chamber. Pull starter rope slowly several times to
coat internal components. Replace spark plug.
• Store the unit in a dry place and away from pos-
sible sources of ignition such as a furnace, gas hot
water heater, gas dryer, etc.
• Out of reach of children
• If the chainsaw/guide rail should not be disassem-
bled, then always attach the rail protection.
To Next Page
Loading...
Need help?
General
