Scheppach DC500 Translation Of The Original Operating Manual

www.scheppach.com
GB
|
19
8. Assembly / Before commissioning
m ATTENTION!
Always make sure the device is fully assembled
before commissioning!
8.1 Machine stand assembly (g. 3 - 6)
• Secure the two wheels using a washer (15) and a
split pin (16) each (g. 3).
• Secure the right-hand side panel (5a) and the left-
hand side panel (5b) using two llister head screws
(18) and two hexagon nuts (19) (g. 4).
• Now t the intermediate part (13) using a total of
four llister head screws (17) (g. 5).
• Place the housing cpl. with engine (3) on the
machine stand and x it with a total of eight llister
head screws (17) (g. 6).
8.2 Fitting the dust bag (g. 7)
• Attach the dust bag (10) to the lower air outlet using
the clamp tting (11) (g. 7).
8.3 Fitting the lter bag (g. 8)
• Insert the retaining rod (13) into the housing cpl.
with engine (3) and hook in the lter bag (11) (g. 7).
8.4 Fitting the suction hose (g. 9 + 10)
• Attach the suction hose (6) to the nozzle on the
housing cpl. with engine (3) and x it with a hose
clamp (14) (g. 9).
• Attach the hose coupling (8) to the other end of the
hose (6) using a hose clamp (14) (g. 10).
9. Start up
m ATTENTION!
Always make sure the device is fully assembled
before commissioning!
9.1 Switching on/o󰀨, g. 1
• To switch on, set the ON/OFF switch (4) to position
“I”.
• To switch the device o󰀨 again, set the ON/OFF
switch (4) to position “0”.
10. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies
with the applicable VDE and DIN provisions.
The customer‘s mains connection as well as
the extension cable used must also comply with
these regulations.
Damaged electrical connection cable
The insulation on electrical connection cables is
often damaged.
6. Technical data
Suction port, connection Ø 100 mm
Hose length 2000 mm
Air power 1150 m³/h
Pressure di󰀨erence 900 Pa
Filter surface approx. 1 m²
Container volume approx. 75 l
Weight 14 kg
Electric motor 230 V~ / 50Hz
Rated input 550 W
Motor speed 2900 min
-1
Technical changes reserved!
Noise and vibration
m Warning: Noise can have serious e󰀨ects on your
health. If the machine noise exceeds 85 dB (A),
please wear suitable hearing protection.
7. Unpacking
m ATTENTION!
The device and the packaging material are not
children’s toys! Do not let children play with
plastic bags, lms or small parts! There is a
danger of choking or su󰀨ocating!
• Open the packaging and carefully remove the
device.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of
the warranty period.
• Familiarise yourself with the product by means of
the operating instructions before using for the rst
time.
• With accessories as well as wearing parts
and replacement parts use only original parts.
Replacement parts can be obtained from your
dealer.
• When ordering please provide our article number
as well as type and year of manufacture for your
equipment.

Scheppach DC500 Specifications

General

Cleaning type	Dry
Product color	White
Housing material	-
Input power	550 W
Capacity	75 L
Hose length	2 m
Hose diameter	100 mm
Airflow (high speed)	1150 m³/h

Weight and Dimensions

Depth	750 mm
Width	460 mm
Height	420 mm
Weight	16000 g