www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
28
|
GB
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially
hazardous substances that are often contained in
electrical and electronic equipment. By properly dis-
posing of this product, you are also contributing to the
eective use of natural resources. You can obtain in-
formation on collection points for waste equipment
from your municipal administration, public waste dis-
posal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your
waste disposal company.
15. Troubleshooting
WARNING
Always switch the machine o and remove the mains
plug prior to all maintenance and cleaning work.
Fault Possible cause Remedy
Saw blade without
pins loosens after
switching o the
engine
Saw blade clamping screw (28/29) not
tightened enough
Tighten the saw blade clamping screw (28/29)
Motor does not start Failure mains fuse Check the mains fuse.
Extension cable defect Change extension cable.
Fine-wire fuse defective Check the ne-wire fuse and, if necessary,
replace it with a ne-wire fuse of the same type.
Connections on the motor or switch defect Have it checked by an electrician.
Motor or switch defect Have it checked by an electrician.
Saw blades brake Tension set incorrectly Set correct tension
Load too high Feed workpiece more slowly
Incorrect saw blade type Use correct saw blades
Workpiece not fed straightly Avoid lateral pressure
Saw blade oscillates,
not aligned straightly.
Holders not aligned Open the screws that fasten the holders. Bring
the holders into the vertical position and tighten
the screws again.
To Next Page
Loading...
Need help?
General
