www.scheppach.com
26
|
GB
DIN EN 61000-3-11
•
•
tion points that
a.
b.
the mains of at least 100 A per phase.
•
ate the product meets one of the two requirements,
AC motor 230 V/ 50 Hz
Mains voltage 230 Volt / 50 Hz.
12. Cleaning
Attention!
ing work on the equipment.
some soft soap. Do not use cleaning agents or sol
the equipment. Ensure that no water can get into the
interior of the equipment.
13. Transport
transport.
The machine can be transported on the wheels at an
14. Storage
Cover the electrical tool in order to protect it from
dust and moisture.
Store the operating manual with the power tool.
15. Maintenance
Attention!
tenance work on the equipment.
We recommend:
• The splitting wedge is a wearing part that needs to
be sharpened or replaced after wear.
• The combined gripping and controlling device must
remain smooth running. Lubricate with a few drops
• Keep splitting wedge drive clean of dirt, wood shav
ings, bark, etc.
• Lubricate slide rails with grease.
When must the oil be changed?
Change the oil after 150 working hours.
Oil change (g. 17 - 20)
1. Move the log splitter into the start position and pull
out the mains plug.
2.
3. Turn the log splitter on the support leg side as
Dis
4. machine on the motor side as shown in
5.
screw it back in to the machine that is still in a
6. Now screw the oil drain screw with dipstick back
splitting log several times.
7. Check the oil level one last time and top up with a
little oil if required.
Dispose of the used oil in a correct manner at a
public collection facility. It is prohibited to drop
old oil on the ground or to mix it with waste.
Connections and repairs
Please provide the following information in the event
To Next Page
Loading...
