Scheppach HS110 - Troubleshooting

40 GB/IE/NI
18. Troubleshooting
Fault Possible cause Possible cause
1. Blade dissolves
after switching
off the engine
To slightly tightened fastening nut Tighten the right hand thread nut
2. Engine will not
start
a) Failure mains fuse a) Check mains fuse
b) Defective extension cable b) Replace extension cord
c) Connections on motor or switch
not in order
c) Repair by electrical specialist
d) Motor or switch faulty d) Repair by electrical specialist
3. Motor wrong
direction of rota-
tion
a) Capacitor faulty a) Repair by electrical specialist
b) Wrong connection b) Exchange polarity of outlet by an qualiied
electrician
4. Motor will not
work, the fuse is
activ
a) Cross section of the extension
cable does not suficiently
a) see „Electrical connection“
b) Overload by a blunt saw
blade
b) Change saw blade
5. Fire marks on
the cutting
surface
a) blunt saw blade a) Sharpen or change saw blade
b) wrong saw blade b) Change saw blade