www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
25
15. Troubleshooting
The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool fails to
work properly. If the problem persists after working through the list, please contact your nearest service workshop.
Fault Cause Remedy
Engine will not start
No fuel in the tank. Fill the tank up.
Fuel valve closed. Open the fuel valve.
Air lter dirty. Clean the air lter.
Engine switch is set to "OFF". Set the engine switch to "ON".
Recoil starter defective. Repair the recoil starter.
No engine oil. Rell the engine oil.
Spark plug dirty. Clean the spark plug
Engine oil level too low (oil warning
lamp is ashing).
Rell the engine oil.
On/off switch for motor operation
set incorrectly.
Set to the correct position
Engine is running loudly/
irregularly
Spark plug dirty Clean/replace the spark plug.
Air lter severely dirty Clean/replace the air lter.
Fuel contaminated/stale Drain and replace the fuel.
Choke lever set to "CHOKE" Set the choke lever to "RUN"
Incorrect fuel - diesel instead of
petrol
Drain the fuel and ll with the correct fuel
No electrical output Fault in the a.c. power generator
For service under warranty, inform your repre-
sentative
Engine will not switch off Ignition switch-off wire defective
Close the fuel valve and wait until the engine
shuts off; call customer service
To Next Page
Loading...
