REMOTE CONTROL
Yes, this preamp comes with a remote control. Unlike earlier Sagas,
this is now a fancy milled aluminum model. It’s still inexpensive to
replace in case you lose it or want another one, however.
1 Input. Press this button to select the input you want to listen to. If
you skip the input, keep pressing—it cycles back around.
2 Volume Up/Down. Press the up arrow to turn volume up, press the
down arrow to turn it down. Simple as that.
3 Output. Press to change between passive and tube hybrid buffer
output.
4 Mute. Press to mute the preamp.
Changing the Battery
1. Flip the remote over to reveal a single hole on the back.
2. Push the remote open by inserting the end of an open paper clip into
the hole in the back and pushing rmly. It’s held together with magnets.
3. Replace the battery inside with one of the same type.
4. Reassemble the remote by rst inserting the clear LED in the front,
then dropping the panel down onto the matching magnets. Press
down gently to pop the panel in place.
To Next Page
Loading...
