Schlage BE468 - STEP 4: INSTALL TOUCHSCREEN ASSEMBLY; Mount Exterior Touchscreen

STEP 4
4a: Install the Touchscreen on the outside
of the door.
Note: if you have a crossbore (see step 2) that is slightly
less than 2 1/8” (54 mm), the lock may not install smoothly.
You can then remove the spacer to improve fitment.
Always remove the space for a 1 ½” (38 mm) crossbore.
INSTALL THE
TOUCHSCREEN ASSEMBLY
The clips snap into the crossbore (see step 2)
to assists in holding the keypad on the door.
The Touchscreen Assembly should install
smoothly. If it does not, check that the bolt is
set to the correct backset (see step 2).