Schleuniger EcoCut 3300 - Configuring the Machine; Setting Back to Factory Default

11. Maintenance / maintenance schedule
Reference Manual |Edition 4.0 (10-2013) |
EcoCut 3300
63|108
11.8.2
Configuring the machine
WARNING
Danger if operated by unqualified personnel!
Any changes in the screen „Configuration EcoCut
3300“ affects the behavior of
the machine and should only be handled by experienced and trained personnel.
This menu item is only accessible for persons with password level „Service“
Contact your local Schleuniger representative.
1» Switch on the machine.
2»
5
Based on the main menu go to the menu "Password" with the key [5].
3»
Select [1] „Level“.
4» With [@] select the password level "Service".
5» [ENTER]
6» Enter the "Service" password.
7» [ENTER]
8» 2 x [MENU]
9»
3-3
From the main menu select the screen „Configuration“ with the key [3].
10»
Press [3] "Product name" (this screen contains all the machine settings for the EcoCut 3300).
▄
Display Contrast: Adjusts the contrast level of
the display.
▄
Blade resolution: Amount of pulses / cutter
head revolutions (measured before the drive).
▄
Feed resolution: One encoder pulse corre-
sponds to this feeding in mm or inch.
11.8.3
Setting back to factory default
If a fault condition occurs on the EcoCut 3300 always proceed first according to chapter "10 Diagnostics /
troubleshooting (Page 55)".
Not until a detailed labor trying to bring the EcoCut 3300 into operation again, the option of switching the
whole machine back to their factory settings may be considered.
NOTICE
Caution property damage!
The function "Factory default" is only accessible for persons with password level
„Supervisor“.
All settings are put back to their factory settings.
Caution: All wire programs are deleted!
Contact your local Schleuniger representative.