1. General
Reference Manual |Edition 4.0 (10-2013) |
EcoCut 3300
9|108
GENERAL
Thank you for your trust in the Schleuniger technique! You have acquired a high performance Schleuniger
product, designed and manufactured in our factory to your needs. Read through this manual with due
care and attention. It contains important tips and safety instructions, which allow precise and reliable
wire/cable production.
1.1
MANUFACTURER
In this Manual, Schleuniger AG Thun, Switzerland is referred to as manufacturer and abbreviated with
„Schleuniger“.
Schleuniger AG Phone: +41 (0)33 334 03 33
Bierigutstrasse 9 Fax: +41 (0)33 334 03 34
3608 Thun Email:
Mailto:info@schleuniger.ch
Switzerland Web: http://www.schleuniger.com
1.2
MANUFACTURING DATE / PRODUCT TYPE
See “EG-Declaration of Conformity (Register 2)“ of the ring binder.
1.3
INFORMATION ABOUT THE OPERATOR'S HANDBOOK
▄
The Operator's Handbook is part of the product and contains all the relevant information necessary to
operate the product efficiently and safely as intended.
▄
The mentioned safety notes and directions and as for the application field valid local accident preven-
tion regulations and general safety regulations must be complied.
▄
If the product changes hands, the Operator's Handbook must be supplied to the new owner.
▄
Make sure to update any relevant safety changes and corrections to the Operator's Handbook which
are available. Ask your local Schleuniger distributor for updates.
1.3.1
Contents of the manual
General
Each person using the product must be properly trained and have read and understood the Operator's
Handbook. This is also imperative, even when the respective person has operated such a product or simi-
lar previously and where they have been trained by the manufacturer.
The Operator's Handbook is no longer valid, if any of its contents (except a Quick Start Card, where availa-
ble) are removed or is changed on the data storage medium.
As Operator's Handbook we declare:
▄
In printed form the entire content of the folder according to the contents table.
▄
In electronic form, this „Reference Manual“, and the document „Parts Catalog“.
Construction
We are trying to make the operation of our products as easy as possible. To achieve this we have devel-
oped a concept for the Operator's Handbook.
The Operator's Handbook consists of at least three parts:
To Next Page
Loading...