Table of contents
Reference Manual |Edition 4.0 (10-2013) |
EcoCut 3300
7|108
14
APPENDIX 77
14.1
SOFTWARE UPGRADE ........................................................ 77
14.1.1 Installing Iguana ............................................................... 77
14.1.2 Downloading upgrade file........................................................ 77
14.1.3 Upgrade procedure............................................................. 78
14.2
CONNECTOR HS / PF ......................................................... 79
14.2.1 For use with a PreFeeder......................................................... 79
14.2.2 For use with a HotStamp......................................................... 80
14.3
PRE-/POSTFEED INTERFACE (PPI, OPTION) .......................................81
14.3.1 POSTFEED interface............................................................. 82
14.4
BLOCK DIAGRAM ............................................................90
14.5
LUBRICATING GREASE MICROLUBE GBU-Y 131 ...................................91
INDEX 105
To Next Page
Loading...
