Schmidt SC Series - Delivery and Unpacking

9
2.6 Unpacking
Unpack the display unit and inspect it for any shipping damage. Notices of defect must
be announced immediately, in writing, at the latest within 7 days on receipt of the goods.
2.5.1 Optional accessories
Code CAN: CAN-bus interface
Code A3: Current output 4 - 20 mA (0 - 10 V analog signal not applicable)
All options must be factory fitted, re-fitting is only possible at the manufacturer‘s facility.
EK0612 Connecting cable for TS sensor with 1 diode plug and open ends, length 3 m
EK0614 Connecting cable for TS sensor with 1 diode plug and open ends, length 5 m
EK0615 Connecting cable for TS sensor with 1 diode plug and open ends, length 10 m
EK0620 Connecting cable for FS sensor with 1 sub-miniatur connector and open ends,
length 2 m
EK0621 Connecting cable for FS sensor with 1 sub-miniatur connector and open ends,
length 5 m
EK0622 Connecting cable for FS sensor with 1 sub-miniatur angle connector and open
ends, length 2 m
EBG800 Converter from RS-422 to RS-232
EK0643 Connecting cable to connect the converter to PC, length 2 m
SW-TI3 Software »Tension Inspect 3« for displaying and saving readings on a PC
(Windows 7 and higher)
2.5 Delivery includes
 SC-PM display unit
 3 alligator clips
 USB cable
 instruction manual