12
3.2.2 Switch-off
- Switch off the external power supply.
3.2.1 Switch-on
To switch on the SC-PM:
- Switch on the external power supply.
The TFT display successively shows:
the adjusted tension range, the adjusted channel ID (RS-422 interface), the CAN-Bus ID
(only if the display is equipped with the optional interface), as well as software and hard-
ware version (e. g. SW 1.0)
3.2 Initial setup
Requirements:
- Install the sensor at the desired measuring location.
- Connect the external power supply.
- Connect the SC-PM to the supplied sensor with one of the optional available cables.
In no event shall Hans Schmidt & Co GmbH take over any warranty coverage
for, or shall be held liable for, any damage resulting from self-made cables.
3.3 Instrument settings
- Press the and buttons simultaneously to access the main menu.
- The and buttons can be used to select the various menu items of the main
menu, the submenus and the settings menus.
- Press the button to open the selected menu; by pressing the and button
you can close the main menu, while a submenu can be exited by pressing the key.
- In menus with multi-digit fields (e.g. min Alarm) use the buttons to move forward
between the digits. With the and buttons the particular value can be set.
- Press the button to save the settings and exit the settings menu or press
the to exit the current menu without saving.
To Next Page
Loading...
Need help?
General
