User Manual - LLS 3
Page 30
iv. Not in Correct Mode: Some commands require a specific mode before the value can be altered:
&nym
1. y = command character
2. m = constant character denoting not in correct mode
v. Command Timeout: If a command is not completed (i.e., a <CR> is not sent) within 10 seconds
of when the first character is received by the LLS 3 : &ni
Command Summary
Activate/Deactivate UDP-Netfinder “&afx” x=0,1,?
Get Dynamic Ethernet Gateway Address
“&agd”
Get/Set Static Ethernet Gateway Address
&agsxxx:xxx:xxx:xxx” xx’s = address or ?
Get Ethernet Dynamic IP Address “&aid”
Get/Set Ethernet Static IP Address “&aisxxx:xxx:xxx:xxx” xx’s = address or ?
Get Dynamic Ethernet Subnet mask “&asd”
Get/Set Static Ethernet Subnet maskic “&assxxx:xxx:xxx:xxx” xx’s = address or ?
Get/Set Ethernet DHCP mode
(and reset of network interface) “&am” x=0,1,2?
Get/Set TCP Port “&apx“
Get Ethernet link status “&au”
Get Light Source Status “&c”
Get LED Temperature “&ct”
Get/Set Equalizer Mode Control “&ex” x=0,1,?
Get/Set Equalizer Calibration value “&ebxxx” xx=000-F7F, ?
Perform Equalizer Auto-Calibration “&ec”
Get Equalizer internal intensity value “&ed”
Get/Set Equalize Loop Process Value “&ee”
Get/Set Equalizer Hold “&eh”
Get/Set Equalizer Init Delay “&ei”
Get Equalizer Meter Value “&ev”
Get Equalizer Stability Value “&es”
Get Firmware Level “&f”
Get/Set Lamp Intensity: “&ixx” xx=00-FF, ?
Get/Set Shutdown signal behavior “&jx” x=0,1,?
Get/Set Front Panel Controls and Analog Input Lock:
“&kx” x=0,1,?
Get/Set Light Source ON/OFF: “&lx” x=0,1,?
Get Light Source Control Mode “&m”
Restore Factory Defaults: “&o”
Restore Factory Defaults but preserve network settings:
“&o2”
Get/Set Triggered Strobe Intensity: “&pixx” xx=00-FF, ?
Get/Set Triggered Strobe Delay: “&pdxxxx” xxxx = 0000 – 9999, ?
Get/Set Triggered Strobe On-Time: “&poxxxx” xxxx = 0050 – 1000, ?
Get/Set Triggered Strobe Mode: “&pmx” x=0,1,?
Get Device Name Query: “&q”
Get/Set Restore Settings on Power Up: “&rx” x=0,1,?
Get/Set Save Settings After Each change:
“&sx” x=0,1,?
Restore Settings Now (if &r=0): “&t”
Get Light Source Serial Number: “&z”
To Next Page
Loading...
