SCHOTT LLS 3 - Page 31

User Manual - LLS 3
Page 31
Command Details
i. Activate/Deactivate UDP-Netfinder &afx
Activates/Deactivates Netfinder protocol. This allows for using UDP to find LLS 3 devices
on a network. Netfinder adds processing time and slows down other functions of the LLS
3. It is recommended to deactivate if not required.
x = command parameter
0 = Netfinder off
1 = Netfinder on (factory default)
? = query value
return value: &afx where “x” is either 0 or 1 depending on whether or not Netfinder is
active.
ii. Get Dynamic Ethernet Gateway Address &agd
Gets the network interface’s Dynamically assigned gateway address
return value: &agdxxx:xxx:xxx:xxx where “xxx:xxx:xxx:xxx” is the network gateway
address. If in static mode the LLS 3 will return “&agd000:000:000:000”.
iii. Get/Set Static Ethernet Gateway Address &agsxxx:xxx:xxx:xxx
Gets/Sets the network interface’s static gateway address
xxx:xxx:xxx:xxx = Network Gateway. Must enter 0’s for single and double digits. For
example, &ags192:168:000:001. Value of “xxx” is between 000 and 255
? = query network Gateway, “&ags?”.
return value: &agsxxx:xxx:xxx:xxx where “xxx:xxx:xxx:xxx” is the network gateway
address.
Factory Default is: 192:168:000:001
iv. Get Dynamic Ethernet IP Address &aid
Gets the network interface’s Dynamically assigned IP address
return value: &aixxx:xxx:xxx:xxx where “xxx:xxx:xxx:xxx” is the network gateway
address. If in static mode the LLS 3 will return “&aid000:000:000:000”.
v. Get/Set Static Ethernet IP Address &aisxxx:xxx:xxx:xxx
Gets/Sets the network interface’s static IP address
xxx:xxx:xxx:xxx = Network IP address. Must enter 0’s for single and double digits. For
example, &ais192:168:000:002. Value of “xxx” is between 000 and 255
? = query network IP address, “&ais?”.
return value: &aisxxx:xxx:xxx:xxx where “xxx:xxx:xxx:xxx” is the network IP
address.
Factory Default is: 192:168:000:002
vi. Get Dynamic Subnet Mask &asd
Gets the network interface’s Dynamically assigned Subnet Mask
return value: &asdxxx:xxx:xxx:xxx where “xxx:xxx:xxx:xxx” is the network Subnet Mask.
If in static mode the LLS 3 will return “&asd000:000:000:000”.
vii. Get/Set Static Ethernet Subnet Mask &assxxx:xxx:xxx:xxx
Gets/Sets the network interface’s static Subnet Mask
xxx:xxx:xxx:xxx = Network Subnet Mask. Must enter 0’s for single and double digits. For
example, &ass255:255:255:000. Value of “xxx” is between 000 and 255
? = query network Subnet Mask, “&ass?”.
return value: &assxxx:xxx:xxx:xxx where “xxx:xxx:xxx:xxx” is the network Subnet Mask.
Factory Default is: 255: 255: 255:000
viii. Get/Set Ethernet DHCP Mode (and reset of network interface) &amx
Sets the network DHCP mode
x = command parameter
0 = DHCP off
1 = DHCP on (factory default)