SCHOTT TITRONIC universal - Maintenance and Care; Maintenance Intervals; Maintenance Work Procedures; Handling Interruptions of Use

To Next Page

To Previous Page

10 Storage, transportation and environment

If the TITRONIC

ââ

universal Piston Burette has to be stored temporarily or transported, the original packing

will provide the best protection for the device. In many case, however, this packing is no longer available,

so that a comparable makeshift packing has to be put together. Sealing the TITRONIC

ââ

universal Piston

Burette in a foil has proven to be a good solution.

Before doing so, please make sure

that the dosing unit has been rinsed with distilled water

and contains no liquid.

If the TITRONIC

ââ

universal Piston Burette has to be sent in for repair, please state the titration solution

last used on the accompanying papers or on the TITRONIC

ââ

universal Piston Burette itself. Otherwise the

service department will dispose of the damaged or replaced parts as special waste on the customer’s ac-

count.

The device should be stored in a room meeting the following requirements:

Ü temperature between + 10 and + 40 °C for operation and storage,

Ü humidity according to EN 61 010, Part 1:

max. ref. humidity 80 % for temperatures up to 31 °C,

linear decrease down to 50 % relative humidity at a temperature of 40 °C

Your TITRONIC

ââ

universal Piston Burette will have a very long life,

so that this information is in fact given far too early:

But when the end of its lifetime has come, please observe the regulations of your country and town

regarding disposal.

Related product manuals