9
english
Warning:
Always check your helmet before every ride!
1. Check the Face Shield and sun visor.
2. Check the correct function of the shield and visor mechanics.
3. Check for cracks in the helmet. Strong acid (e.g. battery acid)
can damage the shield bases. If you find cracks or damage,
stop using the helmet immediately.
4. Check helmet for deterioration. If you find deterioration in
any part of a component, either replace that component
or get a new helmet. If these parts come loose and/or fall
off while you are riding, your vision may be blocked, which
could cause an accident resulting in serious personal injury
or death.
5. Check the security of the retention system (see section G.3.).
For checking instructions and procedure see also section F.
(before every ride) of this manual.
Warning:
Maintain your helmet shields (shield and sun visor)
in good condition!
If your shields become too scratched or uncleanable, replace
them with new ones. Impaired visibility may cause accidents.
Clean your shields only with mild soap diluted in tap water.
Rinse well with clean tap water, and dry with a soft cloth.
Never use benzene, gasoline, glass cleaner or any other
solvents.
Do not attach stickers or adhesive tape to the shields, as this
will weaken the hard coating, damaging the shields. Do not
drive with a dim or blurred shield. Impaired vision can cause
an accident resulting in serious personal injury or death.
To Next Page
Loading...
Need help?
General
