SCHUBERTH SRC-System PRO Schuberth

7.2 MAKING AND RECEIVING PHONE CALLS
Answer a call
Tap
µ
or speak a ny word loudly to an swer by VOX
Reject a call
Remain si lent for 15 seconds, or press
µ
for 2 seconds
End a call
Tap
µ
Voice Dial* (if supported
by mobile phone)
Press
for 2 seconds and follow the prompt from the
mobile
Redial*
Press
for 2 seconds
Hot Dial*†
Tap
µ
three times
Set default mobile‡
While on a phone call, press for 5 seconds
Change default mobile
In Standby, press
µ
for 5 seconds
INTERCOM CONFERENCE MODE
Add/Remove Channel “A”
to/from a call
Tap
v
while on a phone call
Add/Remove Channel “B”
to/from a call
Double-tap
v
while on a phone call
* This feature is not available during mobile calls.
† Before using Hot-Dial, congure your Hot-Dial number via the Cardo Community or the Cardo
Smartset App.
‡ If 2 mobile phones are paired directly to your unit, set one to use as default for outgoing calls.
8. FM RADIO
Your SRC-System™ PRO includes a built-in FM radio with a 6 Preset
memory and RDS (Radio Data System).
RDS allows the radio to automatically retune to the strongest
frequency available for the FM station you are listening to when the
signal becomes too weak.
Turn on Radio
ß
In standby, double-tap
µ
Turn o Radio
ß
Press
µ
for 2 seconds
Next Station
ß
With radio ON, tap
µ
Previous Station
ß
With radio ON, double-tap
µ
RDS ON/OFF
(Default: O)
With Radio ON, press
+
and
-
simultaneously for 2 seconds
8.1 RADIO TUNING
Preset stations can be saved via the Cardo Community, the Cardo Smartset App or
directly on your unit.
1. Turn on the Radio.
2. Select a Preset number you wish to set (Preset 1 – 6) by tapping
µ
until the desired
preset is heard.
3. Find an FM station to save using Seek or Scan.
Seek up/down and Save
(Find the next FM station)
Choose a preset by tapping
µ
Press
+
or
-
for 2 seconds
Tap
µ
within 20 seconds to save to current preset
Scan and Save:
(Automatically scans up for
a station)
With Radio ON, press
+
for 5 seconds
To stop search, tap
+
Tap
µ
within 20 seconds to save to current preset
To continue scan, wait for the next station to be found.
7.3 LISTENING TO MUSIC VIA A2DP
Available only on AVRCP compatible Bluetooth audio sources
Play
ß
In Standby, tap
µ
Pause/Stop
ß
Press
µ
for 2 seconds
Next Track
ß
With music ON, tap
µ
Previous Track*
ß
With music ON, double-tap
µ
Music Scan
With music ON, press
+
(scans up) or
-
(scans down) for
5 sec. The rst few seconds of each track will play.
Stop Scan
To stop the scan on the current track, say any word loudly
into the microphone or tap
µ
*With some phone s you may need to repeat this ac tion
SWITCHING BETWEEN A2DP AUDIO SOURCES
If a Music Player is paired, the SRC-System™ PRO will use it as the default A2DP
audio source.
1. Stop the music playback from the current device.
2. Start music playback from the other device.
7.4 MUSIC SHARING
Rider and passenger can listen to the same music (within a range of
10m / 33 ft)
Music Sharing works only with A2DP (Bluetooth stereo) enabled
devices. To share your music with your riding partner, your SRC-System™ PRO
unit [SENDER] needs to be paired to the other unit [RECEIVER] on CHANNEL A and
the RECEIVER must be in Standby mode.
[SENDER] Start/Stop
sharing your music
During A2DP music playback, press
+
for 2 seconds
[RECEIVER] Stop music
sharing
Press
+
for 2 seconds
Phone/Intercom calls and GPS audio navigation will override music playback.
Music Sharing does not transmit voice audio and cannot be used as an Intercom call.
8.2 AUTOMATIC RADIO TUNING
This feature makes nding new stations fast and easy by automatically creating a
temporar y list of 6 radio stations.
1. With the radio on, press
-
for 5 seconds.
2. The radio will search upwards (higher frequency) from the current station and
store the next 6 FM stations it discovers.
3. If desired, repeat to store the next 6 FM stations.
These 6 temporary stations cannot be saved and do not replace the FM Presets you may
have saved.
Turning o the unit will clear the temporary stations and restore the FM Presets.
9. TROUBLESHOOTING
Reboot
If your SRC-System™ PRO stops responding, reset it by turning it o
and then on again (press
s
for 2 seconds ) .
Reset Pairing
(Deletes all
paired devices)
1. In Standby, press
+
for 5 secs until LED ashes RED/BLUE.
2. Press
µ
for 2 seconds until LED ashes 5 times in PURPLE.
English
36 | SRCS Pro SRCS Pro | 37

SCHUBERTH SRC-System PRO Specifications

General

Brand	SCHUBERTH
Model	SRC-System PRO
Category	Two-Way Radio
Language	English