Page 11
Figure 3: Wall mount option
4. Installation
200mm metal pipe
Locking Screw
Min 55mm
200mm ducting
Cord slots at bottom
(6 o’clock position)
Weather shield
upper most
Wall Hanging bracket
NOTE: Ensure that power cord is fed through exit slot and is not allowed to double back restricting
motor inlet.
Attach weather shield using 3 screws provided
when wall mounting. Ensure weather shield is
upper most position (12 o’clock position) when
engaging locking screw
Fix motor module using side locking
screws
1650 Motor
NOTE: Ensure that power cord
is fed through exit slot and is
not allowed to double back
restricting motor inlet.
Wall Hanging bracket
1650 Motor
NOTE: Due to the weight and to create stability for the Isodrive 1650 motor, it is require to use a
wall hanging bracket. Warranty will be void if a hanging bracket is not used.
To Next Page
Loading...
