Schwing VECTOR User Manual

Service Manual
10 V
ECTOR
C
ONTROLLER
-S
ERVICE
M
ANUAL
Control and monitoring components
Controller cabinet (Figure 16)
1. Display window
2. Key: menu control
3. Operating mode selector
• Local mode
• Remote mode
• Ram change mode
4. Momentary contact “I” switch (Start switch)
5. Key switch: E-stop bypass
6. Connector: radio or remote control
Display window (Figure 17)
On start-up, the following data is displayed on screen
(Figure 17):
1. PTO speed
2. Hydraulic oil temperature
3. Oil cooler “ON”
4. Control status
5. Selected mode of operation
6. Concrete pump delivery rate
7. Menu options
NOTE!
After pressing “down arrow” key on the
menu control panel, further operational
data will be displayed:
- Concrete pump hydraulic oil
pressure
- Hydraulic oil level indication
(optional equipment)
- Engine load factor (optional
equipment)
Control status indications
Section 4 (Figure 17) of the screen displays the
following conditions:
Control system is running.
System is ready for start up.
Starting is not possible: switches are not
in neutral position.
Starting is not possible: an emergency
stop is activated
Operating mode display
Section 5 (Figure 17) of the screen displays one of
these modes of operation: Local/Remote/Ram change
HOME HELP
CLEAR ENTER
OFF
QUIT
+
-
START
OK
1
0
2
3
PTO
Menu: [ENTER]=ON
1500 rpm
62˚C
x1000
1
2
3
4
5
6
panelID.eps
Figure 16
Component locations on the
controller cabinet
OK
1
0
2
3
PTO
Menu: [ENTER]=ON
1500 rpm
62˚C
x1000
4
5
7
6
123
allcallouts.eps
Figure 17
Display window data
information
-
menuarrowdwn.eps
OK
Istart.eps
Start
Start
STOP!
estop.eps
localcontrol.eps
remotecontrol.eps

Schwing VECTOR Specifications

General

Brand	Schwing
Model	VECTOR
Category	Control Systems
Language	English