Schwinn 125 - Additional Troubleshooting; Console Shut Off; Fan Issues; Bike Stability and Pedal Issues; Seat Post Stability

33
Console shuts off (enters
sleep mode) while in use
Check data cable integrity
All wires in the cable should be intact. If any are cut or crimped,
replace cable.
Check data cable
connections/orientation
Be sure cable is connected securely and oriented properly. Small
latch on connector should line up and snap into place.
Reset Machine
Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Check magnet position
(requiresshroudremoval)
Magnet should be in place on pulley.
Check RPM Sensor
Contact Customer Care for further assistance.
Fan will not turn on or will
not turn off
Check data cable integrity
All wires in cable should be intact. If any are cut or crimped,
replace cable.
Check data cable
connections/orientation
Be sure cable is connected securely and oriented properly. Small
latch on connector should line up and snap into place.
Reset Machine
Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Unit rocks/does not sit
level
Check leveler adjustment
Leveling feet may be turned in or out to level bike.
Check surface under unit
Adjustmentmaynotbeabletocompensateforextremelyuneven
surfaces. Move bike to level area.
Pedals loose/unit difficult
to pedal
Check pedal to crank con-
nection
Pedal should be tightened securely to crank. Be sure connection
is not cross-threaded.
Checkcranktoaxlecon-
nection
Crankshouldbetightenedsecurelytoaxle.
Clicking sound when
pedaling
Check pedal to crank con-
nection
Remove pedals and reattach fully.
Seat post movement Check locking pin
Be sure adjustment pin is locked into one of the seat post adjust-
ment holes.
Check adjustment knob
Be sure knob is securely tightened.