Schwinn 490e - Page 72

72
Inner Pivot
Shroud
15. Slide the Lower Handlebar outward only about 1 inch
(2.5 cm) from the machine.
16. PushtheInnerPivotShroudtowardthemachine,o󰀨of
the Lower Handlebar. This will release the Cable from the
clips on the Inner Pivot Shroud.
17. With the wire or string still attached to the end of the
Cable, pull the Cable toward the machine out of the Lower
Handlebar. Be sure not to pull the end of the wire or string
into the Lower Handlebar.
18. Remove the wire or string from the Cable, and tie the
wireorstringo󰀨atbothendsoftheLowerHandlebar.This
will be used to route the Cable back through the Lower
Handlebar.
19. Fully remove the Lower Handlebar from the Pivot Rod.
If replacing the Left Main Shroud, repeat the steps to remove
the Left Lower Handlebar.